Cables to Go 29347 Manual Do Utilizador

Installing your USB SuperBooster Dongle 
 

The USB SuperBooster solution has a transmitter unit (sold separately) and a receiver 
unit.  

 

1)  Install the Transmitter Wall Plate in a standard J-box where you want your 

source/computer or connect the Transmitter Dongle to your computer 

2)  Connect the Receiver Dongle to your device using a standard A/B USB Cable or 

A/Mini-B USB Cable 

3)  Use a pre-terminated Cat5/Cat5E/Cat6 cable (recommended) or terminate your 

own cable using the tool-less RJ45 connectors included to connect the transmitter 
and receiver together (see below for instructions on terminating your own cable) 

4)  If using a Transmitter Wall Plate, plug your computer into the transmitter end 

(USB B side) using a standard A/B USB cable (The green LED will light to 
indicate you have a good connection to the wall plate) 

5)  Turn your computer/source on and begin using your device 

 

 
1)  Open the plug by lifting the clear 

plastic end 

2)  Pin 1 of the connector is on the 

left side of the clear plastic shell 
while Pin 8 is on the right side of 
the connector (with RJ45 
connector facing away from you) 

3)  Thread the white/orange 

conductor on your Cat5/5E/6 
cable into Pin 1 

4)  Thread the orange conductor on 

your Cat5/5E/6 cable into Pin 2 

5)  Thread the white/green 

conductor on your Cat5/5E/6 
cable into Pin 3 

6)  Thread the blue conductor on 

your Cat5/5E/6 cable into Pin 4 

7)  Thread the white/blue conductor 

on your Cat5/5E/6 cable into Pin 
5 

8)  Thread the green conductor on 

your Cat5/5E/6 cable into Pin 6 

9)  Thread the white/brown 

conductor on your Cat5/5E/6 
cable into Pin 7 

10) Thread the brown conductor on 

your Cat5/5E/6 cable into Pin 8 

11)  Repeat steps 1-10 to terminate 

the other end of your Cat5/5E/6 
cable 

 

Pin 1 

Pin 8 

 

3