Avaya Bogen 1W Tapped Horn Loudspeaker Folheto
Note: Use 22 AWG shielded, twisted
pair on all wire runs. Com Code:
401882956. Pec Code: 2734-SPK.
Wire Connections
The speaker has screw-type terminals, which are protect-
ed by a clear plastic cover. The cover also acts as a strain
relief for the wires after they are connected. The proce-
dure for connecting the speaker is given in the following
steps:
ed by a clear plastic cover. The cover also acts as a strain
relief for the wires after they are connected. The proce-
dure for connecting the speaker is given in the following
steps:
1
. Loosen the screws that hold the plastic cover and
swing the cover out of the way.
2. Make the connections and dress the wire as shown in
Figure 2.
Figure 2.
3.When using shielded speaker wire, and wiring from
speaker to speaker, wire the shield drains to provide a
continuous shield to the next speaker. Otherwise, clip the
shield wire at the point it emerges from the main cable.
The shield wire should never be terminated on the
speaker.
speaker to speaker, wire the shield drains to provide a
continuous shield to the next speaker. Otherwise, clip the
shield wire at the point it emerges from the main cable.
The shield wire should never be terminated on the
speaker.
4. Do not replace the plastic cover until final power
adjustments have been made.
adjustments have been made.
Note: When connecting from speaker to speaker, the
speaker must be kept in phase.This means that all
number
speaker must be kept in phase.This means that all
number
1
(-) terminals must connect on the same
wire, and all number 2 (+) terminals must be
connected on the other wire.
connected on the other wire.
Final Power Adjustments
1
. Ensure that the speaker is set to its lowest setting (this will prevent an excessively loud page when first used).
2.While a page is in process, adjust the volume control with a screwdriver. Turn clockwise to increase the volume (see table
below).
below).
3. Install the plastic cover.
S PE AKER CA BLE
VOLUME LEVEL
C O N T R O L
(USE ONLY SETTINGS
1 TO 4)
T E RMI NA LS
Switch Setting
3.4 Vrms Input
Impedance (
Ω
)
Power (W)
SPL (dB)
1
720
0.016
89
2
180
0.063
95
3
45
0.25
101
4
10
1.0
107
Figure 2
Impedance and Power Output
Page 2 of 2