Avaya Bogen Multi-Tone Generator Instrução De Instalação
Installation
CAUTION: To reduce the risk of fire or electric shock, do not expose this unit to rain or excessive moisture.
Mounting - The Multi-Tone Generator is designed for wall mount applications. To wall mount this unit, use the four
5/8” pan head screws with nylon washers (screws and washers not provided). Place the unit flush with the wall and
screw it in place.
5/8” pan head screws with nylon washers (screws and washers not provided). Place the unit flush with the wall and
screw it in place.
Wiring - The Multi-Tone Generator can be installed in a variety of configurations, dependent upon specific application
criteria. Figure
criteria. Figure
(on page 4) illustrates a common method of generating a tone signal over program (i.e., tape player,
tuner) input.When the contacts of an external switching device are closed, program input is interrupted by a burst of
one of the tone signals. For longer signal duration, connect the CONTINUOUS and TRIGGER terminals (dotted line).
The tone signal will be continuously generated until the external switch contacts (ALARM CLOSURE) are reopened.
one of the tone signals. For longer signal duration, connect the CONTINUOUS and TRIGGER terminals (dotted line).
The tone signal will be continuously generated until the external switch contacts (ALARM CLOSURE) are reopened.
Power Supply - The Multi-Tone Generator requires a power source of between
1
2 and 48V DC, either positive or
negative ground.
1
. Connect the grounding lead from the chassis to the positive (+) terminal if a positive grounding system is used. Be
certain that the Multi-Tone Generator chassis does not come into contact with any other equipment with a negative
ground.
ground.
2. If a negative-ground system is used, connect the grounding lead to the negative (-) terminal.
The Multi-Tone Generator is capable of generating four distinct signals: pulsed tone, slow whoop, repeating chime, and
steady tone. Each of these four signals may be applied continuously or limited to a double burst (single burst only of
the steady tone) for alarm signalling or pre-announcement. Signals are triggered by an external device that provides a
contact closure. Both tone level and pitch are adjustable.
steady tone. Each of these four signals may be applied continuously or limited to a double burst (single burst only of
the steady tone) for alarm signalling or pre-announcement. Signals are triggered by an external device that provides a
contact closure. Both tone level and pitch are adjustable.
The Multi-Tone Generator will accept a high-level (max.
1
.5V RMS) input from a program source, such as a tuner or
tape deck.Tone signal precedence over program input is built-in.
Description
Your carton contains:
* Multi-Tone Generator Unit
* Power Supply
* Male RCA to Wires Connector
* Female RCA to Wires Connector
* Installation and Use Manual
* Multi-Tone Generator Unit
* Power Supply
* Male RCA to Wires Connector
* Female RCA to Wires Connector
* Installation and Use Manual
Package Contents
Multi-Tone Generator
SIG OUT
COM
VDC
+ 12-48 -
TBA
AUDIO IN
REM STATUS
PITCH
-TRIGGER
-RESET
-STEADY TONE
-PULSED TONE
-SLO WHOOP
-CHIME
-CONTINUOUS
TONE LEVEL
Page 3 of 4