Avaya 38DHB0002UKDD Manual Do Utilizador

How Do I? 

Part 2 Voice Over IP - Page 91 

The IPNC S type interface must be used in the case where there are IP 
Endpoints directly attached to the LAN interface of the IPNC. The S type 
channels can also be used to provide IP connectivity between INDeX systems 
when simple call features or non-voice IP connectivity is required. 

 

Step 1 
Ensure that INDeX has IPNC license (see page 6).

 
This allows an IPNC (one license per IPNC) to 
have 32 channels on the INDeX backplane 
providing 2048K Bandwidth. 
 

Step 2 
From INDeX programming, ensure that the next 
Subscriber number is correct. Refer to the INDeX 
Programming Manual for details. 

 
This is to ensure that when the IPNC starts the 
Subscriber channels allocated to each channel (32 
with a license) increments numerically. This 
ultimately makes programming of the INDeX 
easier. 
 

Step 3 
Create a new group on the INDeX. Ensure that 
this new group is a Terminal Sequential group. 
 

 
This group is used in the INDeX Network Routing 
Tables when configuring the INDeX when setting 
up the DPNSS activity. 
 

Step 4 
Program the IPNC subscriber channels into the 
Terminal Sequential group created above. 
 

 
Assign IPNC channels to a Group 

Step 5 
Assign the numbers that are accessible via the 
IPNC group (Assign VoIP Number) 
From the diagram on page 99, Gateway1 would 
be configured with numbers 3000-3100.  

 
The Assign VoIP Number at the remote end allows 
the remote extensions, which are accessible via 
the IPNC, to be routed to the IPNC channel group. 
In some respects this configuration is similar to the 
number at remote node. 
 

Step 6 
Repeat the process from steps 1-5 on the remote 
INDeX. 
 

 
This should now leave the two INDeX node 
networks at a point where the IPNC needs to be 
configured to allow the call to proceed across the 
packet network. 
 

INDeX IPNC Cassette Administration Manual 

How Do I? - Page 91 

38DHB0002UKDD – Issue 7 (22/11/02) 

Part 2 Voice Over IP