Auralex Acoustics Elite Pro System EPS-112T Manual Do Utilizador
CT45 Bass Trap Installation Guide
16.75”
➊
Mark a vertical line 16.75” from the intended
placement corner on both sides.
placement corner on both sides.
➋
Hold
CT45 Bass Trap in corner with edges
aligned to the marked vertical lines.
➌
While continuing to hold panel in place, install
one finish nail though the fabric face and the
hardened edge of the
one finish nail though the fabric face and the
hardened edge of the
CT45. Do not hammer
nail completely flush with the face of the panel.
Make sure finish nail is installed perpendicular
to the wall surface. Repeat in each of the four
corners.
Make sure finish nail is installed perpendicular
to the wall surface. Repeat in each of the four
corners.
➍
Using a nail set or another finish nail, carefully
countersink installed nail so its head goes
through the fabric surface of the
countersink installed nail so its head goes
through the fabric surface of the
CT45 but not
through the hardened edge.
➎
Once the finish nail has been countersunk into
the panel, there may be a small hole remaining
in the fabric covering. Simply scrape the fabric
in this area with your fingernail and the hole will
completely disappear.
the panel, there may be a small hole remaining
in the fabric covering. Simply scrape the fabric
in this area with your fingernail and the hole will
completely disappear.