Atlas GUARDIAN PLMS Manual Do Utilizador

Página de 4
4
598-1095-01
SYMPTOM
Light stays on
continuously.
Light flashes
on and off.
POSSIBLE CAUSE
1. The sensor is pointed at nearby
objects that cause heat to trigger
the sensor. 
(Aim the sensor
away from nearby objects)
.
2. The sensor is pointed toward a
heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. 
(Re-aim
sensor)
.
1. Heat being reflected from other
objects may be affecting the
sensor. 
(Re-aim sensor)
.
2. Light Control is in the Test mode
and warming up. 
(Flashing is
normal under these conditions)
.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker is
turned off.
4. Daylight turnoff is in effect 
(Re-
check after dark)
.
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
1. Light Control may be installed in
a relatively dark location.
2. Light Control is in Test. 
(Set control
switch to an ON-TIME position)
.
1. Light Control may be sensing
small animals or automobile traf-
fic 
(Re-aim sensor)
.
2. Sensitivity is set too high. 
(Re-
duce sensitivity)
.
SYMPTOM
Light will
not come
on.
Light comes
on in
daylight.
Light comes
on for no
apparent
reason.
TROUBLESHOOTING GUIDE
If you experience a problem with your Light Control, first follow this guide. For additional assistance write to:
Atlas Lighting Products, Inc. • Customer Service Department • P.O. Box 2348 • Burlington, NC  27216
FIVE YEAR LIMITED WARRANTY
Atlas Lighting Products, Inc. warrants against defects in materials or workmanship for a period of five years from
the date of purchase for use, and agrees to repair or, at our option, replace a defective unit without charge for
either parts or labor. IMPORTANT: This warranty does not cover damage resulting from accident, misuse of
abuse, lack of reasonable care, the affixing of any attachment not provided with product, alteration of any
attachments factory installed, loss of parts or subjecting the fixture to any but the specified electrical service.
This warranty does not cover failure of the bulb due to accidents, abuse, misuse, vandalism, power surges, and
acts of nature such as lightning damage. No responsibility is assumed for any special incidental or
consequential damages. Damages occurring during transit are not covered by this warranty-including UPS
shipments. To obtain warranty service, mail sales receipt as proof-of-purchase, date and a brief explanation
of the nature of the defect, to the address listed below. You will receive, by mail, a Return Goods Authorization
number and full instructions for returning defective merchandise. All returned goods must be accompanied
by a Return Goods Authorization number issued by Atlas Lighting Products, Inc.
NOTE: No other warranty, written or verbal, is authorized by Atlas Lighting Products, Inc. This warranty gives
you specific legal rights and you may also have other rights which vary from state to state. Some states do not
allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied
warranty lasts, so the above exclusion and limitations may not apply to you.
For information regarding replacement parts please write to:
Atlas Lighting Products, Inc.
Attn: Customer Service Department
P.O. Box 2348
Burlington, NC  27216