ATD Tools Video Gaming Accessories ATD-7470 Manual Do Utilizador

1. Remove saddle from the transmission jack.

2. Drill two

” size holes on the saddle. Ensure the holes are 9

" apart

and, should be located equally away from the saddle edges about 1”

(Refer figures 2 & 3 for location of holes).

note: The integrity of your transmission jack should not be affected by

these two holes as long as the instructions are followed. ATDll warrant

its transmission jack original warranty for this specific fuel tank adapter

installation.

3. Secure the fuel tank adapter to the saddle with two

”-24x1

" bolts,

flat washers, lock washers and nuts provided (Figure 4).

(Refer to Figure 5 for below procedures)
4. Slide support stand (1) over one end of the two arms (2). Repeat

procedure on other end of same arm; Slide support stand (3) over one

end of the other arm. Repeat procedure on other end of same arm.

5. Secure each support stand by inserting snap pin (4) through the aligned

holes on arm, snapping the latch over the end of pin as shown.

6. Insert the

"-16 x 2

" Bolt (5) through the last set of holes in arm and

secure in place with washers, lockwasher and nut provided. Repeat for

other three sides.

7. Secure both bonding cables (6) to the top side of frame base with

"-20x1" bolt and nut provided.

note: Remove paint from top and bottom of plate around the

" diameter

hole.

8. Bolt safety nylon strap (7) to support stand (3). Secure with

"-13x1"

bolt, washer, lockwasher and nut provided. Repeat procedure on other

support stand.

9. The assembly is now ready to use.

inSTALLATiOn

(refer Figure 1 thru 5)

note: Below instruction is illustrating the use of fuel tank adapter conjunction with Model ATD-7430, ATD-7431.
Estimated Time: 30 minutes
Tools required: Drill,

" drill bit, 17mm & 19mm wrenches.

Fig. 4

Fig. 3

Fig. 2

Figure 5 - Assembly instruction

(2) Arm

Support Stand (1)

Support Stand (3)

Arm (2)

Front View

(4) Snap Pin

Bolt (5)

Side View

(7) Safety Strap

Bonding Cable (6)