Artesian Spas Grand Bahama Manual Do Utilizador

7) Have the spa deck installed by a knowledgeable contractor to ensure

proper support.

8). If the spa is placed on the ground, even for a short period of time, it

must be supported by stones that are at least 2 inches thick and 12 inch-

es square. A solid foundation is recommended as soon as possible.

INSPECTION

You will want to inspect your spa, prior to filling it up with water. Look for

and remove any debris in the spa tub and in the filter. Verify that pump

plugs are installed on the pumps and the pump unions are tight.

FILLING THE SPA WITH WATER

NOTE: DO NOT fill your spa with hot water straight out of your

water heater or tap. This water may be as hot as 180 degrees F and

will cause damage to the surface and plumbing of the spa. This

will void your warranty. Level the spa before filling.

1) Prepare to fill the tub by removing all debris.

2) Remove the filters from your spa (see Removing, Installing and

Cleaning Filters, page 28)

3) Insert the hose in the area where the filter was located as shown in

the picture below.