Arboria Cascadia Arbor Manual Do Utilizador

Lay one of the 2” x 6” header boards flat on your work surface, 
with the 12 small pilot holes facing up and the shorter side toward 
you. 

STEP 1 

Turn the assembly over and attach the second header following the same method as the first. Take special care to: 

• 

Make sure the inside edge of the panel (the edge with the single hole 12” from the top of the post) is facing inward. 

• 

Be careful to use the matching pair of screw holes to give you the opening width you have selected. 

STEP 2 

Place one of the two lattice side panels on its edge, with the upper 
end (2 screw holes, closely spaced) toward the header board and 
the inside edge of the side post (single screw hole about 12” from 
the top) toward the center of the header board. 

Drive one of the 1 5/8” screws through the top hole in the bottom 
side post, holding the frame up a bit so that the point of the screw 
stick through about 1/2” inch. 

Choose the pair of pilot holes in the header for the width of open-
ing you prefer. 
 

Outside Holes - for a 48 ½” width opening 
Center Holes - for a 42 ½” width opening 
Inside Holes - for a 36 ½” width opening 
 

Place the top edge of the frame over the header board with the 
point of the screw lined up with the upper pilot hole of the pair 
you have selected. When you are sure that the screw point is prop-
erly aligned, drive it firmly into the header.