AMX Computer Control PC Presenter Manual Do Utilizador

This section describes how to program the PC Presenter. Before programming, make sure the PC 

Presenter is properly installed:

 

Verify that the PC keyboard and mouse are connected to the AXR-MSE, and the 

AXR-MSE is connected to the keyboard and mouse ports on the CPU.

 

Device DIP switch settings (on the front panel of the AXR-MSE) match the device 

number assigned to it in the Axcess program.

There are two primary ways to use the PC Presenter: Stand-alone operation (not connected to 

AXlink), and AXlink operation. In stand-alone mode, the PC Presenter controls PC keyboard and 

mouse functions. Connected to a Central Controller via AXlink, the PC Presenter can control 

devices on the AXlink bus.

For information on installing the PC Presenter, refer to the Installing the PC Presenter for AXlink 

Operation section.

The PC Presenter has two modes of programming in stand-alone mode: command mode, in which 

you give specific commands to the PC Presenter, and programming mode, in which you assign 

specific PC keystrokes to pushbuttons on the transmitter.

The PC Presenter has a set of six commands that allow you to clear the PC Presenter memory, list 

the commands, list the keycodes stored in PC Presenter memory (in both short and long form), 

display the amount of memory available in the PC Presenter, and display firmware version and 

copyright information. 

To use the PC Presenter commands:

Begin at a DOS prompt on the PC that is connected to the AXR-MSE.

At the DOS prompt, enter program mode by selecting and holding the following keys on the 

PC keyboard:

CTRL, then ALT then "." (period key).

When these keys are released, program mode will be indicated by the following characters at 

the DOS prompt:  

C:\>rem Press command key or transmitter button

C:\>rem

PRGM EX. 1