Alpine DCS-BT1 Manual Do Utilizador

18

 To comply with FCC RF exposure requirements, the device and the antenna for 
this device must be installed to ensure a minimum separation distance of 20 cm
or more from a person’s body. Other operating confi gurations should be 
avoided. 

NOTE: This equipment has been tested and found to comply with the limits for 
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular 
installation. 

If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of 
the following measures: 
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
- Connect the equipment into an outlet on a circuit diff erent from that to 
  which the receiver is connected. 
- Consult the dealer or an experienced technician for help. 
 

IC statement: 
Operation is subject to the following two conditions: 
1) this device may not cause interference. 
2) this device must accept any interference, including interference that may 
cause undesired operation of the device. 
  
IC radiation exposure statement: This equipment complies with IC radiation 
exposure limits set forth for an uncontrolled environment. 
End users must follow the specific operating instructions for satisfying RF 
exposure compliance. 
This transmitter must not be co-located or operating in conjunction with any 
other antenna or transmitter. 

    

This Warranty gives you specific legal rights, and you may also have other rights 
which vary from state to state and province to province. In addition, some states
/provinces do not allow limitations on how long an implied warranty lasts, and 
some do not allow the exclusion or limitation of incidental or consequential 
damages. Accordingly, limitations as to these matters contained herein may not
apply to you.

    

This Warranty is not valid unless your Alpine car audio product has been installed 
in your vehicle by an Authorized Installation Center, and this warranty stamped upon
installation by the installation center.

    

Should the product require service, please call the following number for your 
nearest Authorized Alpine Service Center.

                                

Or visit our website at; http://www.alpine-usa.com

ALPINE ELECTRONICS OF AMERICA, INC., 
19145 Gramercy Place, Torrance, California 90501, U.S.A.
ALPINE ELECTRONICS OF CANADA, INC., 
7300 Warden Ave., Suite 203, Markham, Ontario L3R 9Z6, Canada
Do not send products to these addresses.
Call the toll free telephone number or visit the website to locate a service center.

This device complies with Part 15 of FCC Rules. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) This device must 
accept any interference received, Including interference that may cause 
undesired operation. 
Changes or modification not expressly approved by the party responsible for 
Compliance could void the user’s authority to operate the equipment. 
Connecting of peripherals requires the use of grounded shielded signal cables.