Agri-Fab 45-03085 Manual Do Utilizador
11
TINE CARE
For best results — Tine Blades should be kept
•
reasonably sharp. The Tine Blade can be sharpened
on a grinding wheel. Do not attempt to sharpen Tines
while they are mounted to Tiller.
on a grinding wheel. Do not attempt to sharpen Tines
while they are mounted to Tiller.
WARNING: Shut off (disengage) the Tine
Clutch Lever, the Tiller Engine and the
Tractor Engine before making any repairs.
Clutch Lever, the Tiller Engine and the
Tractor Engine before making any repairs.
SPARE TINE DRIVE BOLTS
The Tiller drive components are protected from
•
damage by (shearable) Grade 5 hex bolts in the
Tine Assemblies. The hex bolts drive the tines and
hold them in the proper location. Should the Tine
Assemblies strike or pick up a large hidden object
or become jammed, the hex bolts will break and the
drive components will not be damaged.
Two extra tine hex bolts and nuts are included with
Tine Assemblies. The hex bolts drive the tines and
hold them in the proper location. Should the Tine
Assemblies strike or pick up a large hidden object
or become jammed, the hex bolts will break and the
drive components will not be damaged.
Two extra tine hex bolts and nuts are included with
•
the tiller. They are located in the Tiller Stake Support
Bracket on the rear of the Tiller.
The tine hex bolts are designed to be loose fit. Do not
Bracket on the rear of the Tiller.
The tine hex bolts are designed to be loose fit. Do not
•
attempt to use a bolt or pin that is larger or harder
than the original Grade 5 hex bolts.
than the original Grade 5 hex bolts.
ENGiNE
•
Follow the instructions in the
SERVICE & STORAGE
section of the Engine Manual.
TiLLER
Clean entire tiller (See
•
CLEANING in the
MAINTENANCE section of the manual).
Inspect and replace belts, if necessary (See
Inspect and replace belts, if necessary (See
•
belt replacement instructions in the Service and
Adjustments section of this manual.
Lubricate as instructed in the
Adjustments section of this manual.
Lubricate as instructed in the
•
MAINTENANCE
section of this manual.
Be sure that all nuts, bolts and screws are securely
•
fastened. Inspect moving parts for damage, breakage
and wear. Replace if necessary.
Touch up all rusted or chipped paint surfaces; sand
and wear. Replace if necessary.
Touch up all rusted or chipped paint surfaces; sand
•
lightly before painting.
If possible, store tiller indoors and cover it to protect
If possible, store tiller indoors and cover it to protect
•
from dust and dirt.
Cover tiller with a suitable protective cover that does
Cover tiller with a suitable protective cover that does
•
not retain moisture. Do not use plastic. Plastic cannot
breathe, which allows condensation to form and will
cause your unit to rust.
breathe, which allows condensation to form and will
cause your unit to rust.
WARNING: Never cover Tiller while
engine and exhaust areas are still warm.
engine and exhaust areas are still warm.
Immediately prepare your tiller for storage at the end of
the season or if the unit will not be used for 30 days or
more.
the season or if the unit will not be used for 30 days or
more.
CAUTION: Never store the tiller with
gasoline in the tank inside a building,
where fumes may reach an open flame
or spark. Allow the engine to cool before
storing in any enclosure.
gasoline in the tank inside a building,
where fumes may reach an open flame
or spark. Allow the engine to cool before
storing in any enclosure.
SERVICE AND ADJUSTMENTS
STORAGE