Agri-Fab 45-03085 Manual Do Utilizador

4

Cut from top to bottom all four corners of the carton 

• 

and lay panels flat. See figure 1.
Remove the lag screw that holds the floating hitch to 

• 

the packing skid.
Disassemble and discard carton's wood top and side 

• 

supports.
Remove four hex bolt, hex nuts and flat washer from 

• 

the hold down brackets at the rear of the carton.
Remove and save the two Flat Washers and Cotter Pins 

• 

from rear axle. Reuse when attaching gauge wheels.
Discard all other packing hardware and hold down 

• 

brackets.

Assemble Gauge Wheels onto the Rear Axle with 

• 

the extended end of Hub facing inward. Secure with 
the Flat Washers and Cotter Pins which you removed 
from the axle during unpacking. See figure 2. 

3/8" NYLOCK
NUT

Attach the floating hitch to the tractor's draw bar. 

• 

Refer to 

OPERATING INSTRUCTIONS on page 6.

Remove the preassembled 3/8" x 2" hex bolt and 3/8" 

• 

nylock nut from the L.H. Tine Assembly. Slide the tine 
assembly onto the Transmission Axle on the left side 
of the tiller and secure with the hex bolt and nylock 
nut. See figure 3. Repeat for the R.H. side.

NOTE:  Weights are not furnished with Tiller. 30 lb. tractor 
wheel weights may be purchased to mount to Tiller if 
extra weight is required. (Refer to 

OPERATION section.)

Remove two Hex Bolts and Nuts from each Tine 

• 

Shield, located approximately 3-1/2" from front edge. 
See figure 4.
Place (Wheel) Weights on Tine Shield and secure 

• 

with long Bolts and Nuts furnished with Weights. See 
figure 4.