Adtran 220T1 Manual Do Utilizador
960 Stewart Drive Sunnyvale, CA 94085 USA Phone +1.408.331.3300 +1.877.80SHORE Fax +1.408.331.3333 www.ShoreTel.com
- 11 -
Begin on Channel 1 (do not click on the Edit option), configure the “Port Type” to “Trunk”, then set the “Trunk
Group” to match the trunk group name you created and define a “Description” (the “Description” is a label and can
be anything, but you should define something that is useful and will allow you to determine which channel is being
utilized), then click on the “Fill Down” radio button. This action will automatically populate all of the remaining
channels. Finally, be sure to “Save” all of the changes. This completes all the configuration modifications
necessary on the ShoreTel system.
Group” to match the trunk group name you created and define a “Description” (the “Description” is a label and can
be anything, but you should define something that is useful and will allow you to determine which channel is being
utilized), then click on the “Fill Down” radio button. This action will automatically populate all of the remaining
channels. Finally, be sure to “Save” all of the changes. This completes all the configuration modifications
necessary on the ShoreTel system.
ADTRAN Configuration
To get started with the ADTRAN device configuration, refer to the Quick Start Guide and ADTRAN Operating
System (AOS) and documentation CD included in the product box with each device. Quick Start Guides may also
be downloaded from the ADTRAN support Web site at
device name. Once the ADTRAN device is unpacked and powered on, ADTRAN Total Access platforms can be
configured via a command-line interface accessible from a com port connect (9600 8 N 1) or via Telnet.
Configuration may also be accomplished using the Web interface GUI that provides step-by-step configuration
guidelines.
Initial configuration will be via the CRAFT port, where you‟ll define an IP address on ETH 0/1, the remaining
configuration will be via the Web interface GUI. Connect to the CRAFT port with the following com port settings,
configuration will be via the Web interface GUI. Connect to the CRAFT port with the following com port settings,
using your preferred terminal emulation application (i.e. Tera Term Pro, Putty, HyperTerm, etc.).
Com Port
Pre-configured for 9600 8 N 1 using a straight through dB 9, RS 232 cable.
Username and Passwords are all set to adtran.
Once you have successfully logged in, perform the following actions:
Pre-configured for 9600 8 N 1 using a straight through dB 9, RS 232 cable.
Username and Passwords are all set to adtran.
Once you have successfully logged in, perform the following actions:
CONFIGURE THE UNIT’S IP ADDRESS
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for the
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for the