Husqvarna DXR-310 Manual Do Utilizador

The remote control, the electronics unit and the pilot 
control valves are the main components in the control 
system. The signals from the remote control are trans-
mitted to the machine via bluetooth or via a cable. The 
electronic unit in the machine transmits the signals 
via the pilot control valves to the hydraulic system by 
converting electric current into hydraulic pressure.

The machine is controlled from the remote control. 
Transmission of signals is either wireless, using blue-
tooth, or via a cable.

The movement of the joysticks is proportional. A small 
movement means that the function moves slowly, a 
larger movement increases the function’s speed pro-
portionally. 

The remote control and the machine are connected by 
means of a pre-programmed ID-code. The code is built 
into the remote control’s bluetooth transmitter and the re-
ceiver on the machine. The ID code cannot be changed.

There is a sticker on the bottom of the remote control 
and on the machine’s bluetooth module with a ID code. 
The ID code ensures that the right remote control is used 
for the right machine. 

Wireless transmission of signals uses bluetooth tech-
nology.

In the event of interference in the communication, the 
frequency changes automatically to guarantee interfer-
ence-free transmission.

Connecting a cable shuts off the wireless communica-
tion.

When the machine is controlled by means of cables, 
the ID code is suppressed and the same remote con-
trol can be used for different machines if these have 
the same control system version.

The battery is a Li-ion type. Operating time is about 
8-10 hours per charge. Extreme cold impairs the bat-
tery’s capacity and operating time. Operating time is 
also affected by the extent to which the display has 
been active.

To save the battery, the display goes into energy save 
mode after 20 seconds. After fi ve minutes of inactiv-
ity the remote control turns off automatically. To use it 
again, it must be turned off and on again.

A message appears on the display approx. 30 minutes 
before the battery is completely fl at. It is not possible 
to activate the remote control if the battery capacity is 
too low.

Before using the remote control for the fi rst time the 
battery has to be charged.

Charging time for a fl at battery is approx. 2-3 hours. 
The diode is orange when charging starts and be-
comes green when the battery is fully charged. When 
the battery is fully charged the charger supplies the 
battery with maintenance current until the battery is 
removed from the charger.

Keep the battery charger dry and protected against 
temperature fl uctuations.

Contact your service workshop regarding problems 
with the machine’s software or for any updates that 
might be needed.

22

 - English