Directed Electronics NAV350 Manual Do Utilizador

   

  

The NAV 350 comes with a car mount kit and a car charger with which you 

can set up the device on a vehicle. Choose a position for the car mount kit 

on the windshield using the suction cup, or on the dashboard using the 

self-adhesive power disc connector. 

 

 

Some countries prohibit the mounting of any electronic device in any location on the 
vehicle dashboard. Be sure to check your local laws for acceptable mounting areas 
before installing the car mount bracket.  

 

 

Some newer vehicle models may have a heat reflective shield embedded in the 
windshield. This may in some cases obstruct the GPS signal reception. If you encounter 

this problem in your vehicle, you need to purchase an external GPS antenna.  

Install the car mount on the surface of a vehicle:  

•  That is smooth, flat and free of dirt and oil 
•  Where the driver can easily view/reach it without taking 

his/her eyes off too far from the road  

•  Where the device will not obscure car controls nor restrict 

the driver's view of the road 

•  Far from the air bag deployment area 

To set up the device on a vehicle:  

This section shows how to install the car mount kit in a vehicle’s windshield 

using the suction cup. For dashboard installation procedures using the 

self-adhesive power disc connector refer to the NAV 350 Portable Navigator 

Starter Guide. 
1. Clean the mounting surface with a glass cleaner and a clean cotton cloth. 
2. If the ambient temperature is below +15°C (60°F) warm the mounting area 
and the suction cup (e.g. with a hair dryer) to ensure a strong suction bond. 
3. Install the car mount on the selected area. 

a.  Fix the suction cup to the selected area with the locking lever facing 

up.  

b.  Flip the locking lever away from you to create a vacuum between 

the suction cup and the mounting surface.