Denso BHT-6000 Manual Do Utilizador

35

Chapter 2.  Getting Started the BHT-6000 and System Mode

Selecting "2: DOWNLOAD" on the SYSTEM MENU
calls up the screen shown at left.

 1  DRIVE A

:

Downloads  a  user  program
file (object file compiled by
the BHT-BASIC 3.0 Compiler)
or data file 

to the RAM.

 2  DRIVE B

:

Downloads  a  user  program
file (object file compiled by
the BHT-BASIC 3.0 Compiler)
or data file 

to the flash ROM.

 3  HT<->HT COPY :

Downloads  all  of  the  files,
system parameters, and cal-
endar clock data stored in
the connected BHT-6000.

This function enables copy-
ing between the BHT-6000s.

For the preparation to be
made preceding the start of
this function, refer to NOTE
below.

Select a desired item by using the numerical keys
or   F5   and   F6   keys, and the selected item
becomes reverse-displayed.  Then press the  ENT
key.

To return to the SYSTEM MENU, press the   C  key.

If you download a file having the same name as one already used in the user area of
the target memory in the BHT-6000, the newly downloaded file replaces the old
one.

NOTE

    DOWNLOAD
  

1:DRIVE A

  2:DRIVE B
  3:HT<->HT COPY

NOTE

Preparation for Copying between the BHTs

Before downloading to the BHT-6000 from another BHT-6000, make the fol-
lowing preparation:

• At each BHT-6000, set the interface port.  The default is an optical interface

(OPT).

Interface setting procedure:  Starting on the SYSTEM MENU, select "4:SET
SYSTEM," "6:COM," and "3:COM PORT."  On the SET COM PORT screen,
select the optical interface (OPT) or direct-connect interface (IFC) of "2:SYS-
TEM MODE."

• When using the direct-connect interface, pull out the connector cover on

each BHT-6000 to expose the direct-connect interface port.  Connect the
BHT-6000s via those ports with the direct-connect interface cable (having 3-
pole mini stereo plugs).  For the details about the cable, refer to Chapter 3,
Section 3.1.

• On the uploading BHT-6000, run System Mode and select "3:UPLOAD" and

"5:HT<->HT COPY."