Danby DWM5500W Manual Do Utilizador

INSTALLATION  INSTRUCTIONS 

Instructions for Use

 

8

 

If the floor is uneven, use the adjustable feet to 

level the machine. 

• Undo the nuts. Rotate the feet to level the 

machine (fig. 5). 

• Fix the nuts (fig. 5.1). 

           

       

 

 

33.5 in. 

 
 

IMPORTANT  

The floor on which the machine stands should be 

dry, otherwise the machine may slide during the 

spinning cycle. 

 
 
 

The hose connections inclusive of the 90º elbow 

and coupling must be connected to the water 

inlet valves located on the rear wall of the 

appliance. The hose connections inclusive of the 

straight line coupling must be connected to the 

water (faucet) supply (See Fig. 6)  

. To ensure efficient operation, the water 

pressure of the water supply should be between 

7 and 116 psi. 

If the pressure exceeds the maximum allowed 

limit, fit a pressure regulator. (Open the tap fully - 

in 15 seconds, 0.8 gal. of water should pour out; 

and this is the minimum pressure of the water 

supply). 

 
 
 

Washing machines designed for connections to 

hot/cold water are equipped with two inlet hoses. 

Each hose is identified with a “red” or “blue” 

stripe running the entire length of the hose.  

Red Stripe = Hot Water Hose Connection 

Blue Stripe = Cold Water Hose Connection. 

Insert rubber washer with screen (filter) inside  

(straight line) coupling and connect to the 

faucet/tap. (Fig. 6) Insert regular rubber washer 

inside (90º) coupling and connect to water inlet 

valve. 

 

 

 
  

IMPORTANT 
The highest allowed temperature of hot water is 
140°F. 

Hook the outlet hose securely over the edge of 
the washbasin or bath tub. The outlet hose can 
also be connected directly to the plumbing outlet, 
the diameter of which should be not less than 1.6 
in. (fig. 7). 
Wall siphon drain must be correctly fitted in such 
manner to enable cleaning. 
If water is drained through a washbasin, always 
check it is drained quickly enough, otherwise an 
overflow may occur or the machine may pump 
the water back. Pull a string through the hole on 
the plastic elbow, and secure the outlet hose to 
prevent it from falling off (fig. 8). 

 

 

 

 

The end of the outlet hose should be raised from 
the floor by not more than 40 in. and not less 
than 24 in. If the hose is positioned higher than 
recommended, the machine will not pump out the 
water. 
 

Connect the appliance to the power supply using 
the power cord. The electrical outlet should be 
equipped with a properly grounded contact 
(safety socket). 
Rated voltage, frequency and other data are 
listed on the rating plate of the machine. 
Your washing machine should be grounded 
and connected to the power supply according 
to local electricity board regulations and 
standards. 
 
Connect to individual branch circuit. 

 

 
WARNING! 
If the supply cord is damaged, it must be 
replaced by the manufacturer or his service 
agent or a qualified person in order to avoid 
hazard. 
• The appliance must be installed so that power 

cord plug is within reach of the appliance.     
DO NOT USE AN EXTENSION CORD 

 
 

 

 

cold           hot