BMW 2015 ActiveHybrid 3 Manual Do Proprietário

the area around the recessed grips. Make
sure that the trim does not become stuck.

4.

Carefully swing out the trim.

1.

Loosen the two holders, arrow 1 and pull
down on the lamp holder to remove, ar‐
row 2.

2.

Unscrew the defective bulb of the revers‐
ing or brake lamp from its socket counter‐
clockwise.

3.

Insert the new bulb.

1.

Slide the bulb holder onto the two guide
pins, arrow 1. Insert the two contacts, ar‐
row 2, into the connections, arrow 3.

2.

Press on the bulb holder. Make sure that
the two exterior holders latch into place.

3.

Swing the trim back onto the trunk lid and
secure.

Follow general instructions, refer to page 

.

These lights are made using LED technology.
Contact your service center in the event of a
malfunction.

When using run-flat tires or sealants, a tire
does not need to be changed immediately in
the event of pressure loss due to a flat tire.
Which is why no spare tire is available.
The tools for changing wheels are available as
accessories from your service center.

The jacking points for the vehicle jack are lo‐
cated at the positions shown.

Position the vehicle jack only at the loca‐
tions shown

There are also hybrid components under the
vehicle that are faded by the underbody panel‐
ing.
Make sure not to damage any of the under‐
body paneling parts.
Otherwise, there is the risk of fatal injury from
electrocution due to damaged high-voltage
components.◀

Seite 219

219

Online Edition for Part no. 01 40 2 960 466 - II/15