BMW 2014 320i xDrive Sedan Manual Do Proprietário

If the desired speed is too high for a curve, the
speed is reduced slightly in the curve, although
curves cannot be anticipated in advance.
Therefore, drive into a curve at an appropriate
speed.
In tight curves, situations may result due to the
restricted detection range of the system in
which a vehicle driving ahead of you may not
be detected at all, or not until after a consider‐
able delay.

When approaching a curve, the system may
react briefly to the vehicles in the next lane due
to the bend of the curve. Any deceleration of
the vehicle by the system can be compensated
for by briefly accelerating. After the accelerator
pedal is released, the system becomes active
again and independently controls the speed.

In some situations, the vehicle cannot drive
away automatically, e.g., on steep inclines or
behind bumps in the road.

The transmitter and receiver units comply with
part 15 of the FCC/Federal Communication
Commission regulations. Operation is gov‐
erned by the following:
FCC ID:

▷

OAYARS3-A

Compliance statement:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:

▷

This device may not cause harmful inter‐
ference, and

▷

this device must accept any interference
received, including interference that may
cause undesired operation.

Any unauthorized modifications or changes to
these devices could void the user's authority to
operate this equipment.

The system cannot be activated if the radar
sensor is not aligned correctly. This may be
caused by damage incurred during parking, for
example.
A Check Control message is displayed if the
system fails.

The system is functional at speeds beginning
at approx. 20 mph/30 km/h.
It maintains the speed that was set using the
control elements on the steering wheel.
The system brakes on downhill gradients if en‐
gine braking action is insufficient.

Seite 125

125

Online Edition for Part no. 01 40 2 925 743 - II/14