BMW 2011 X3 xDrive35i Manual Do Proprietário

Danger of burns
Only change bulbs when they are cool;

otherwise, there is the danger of getting
burned.◀

Working on the lighting system
When working on the lighting system, you

should always switch off the lights affected to
prevent short circuits.
To avoid possible injury or equipment damage
when replacing bulbs, observe any instructions
provided by the bulb manufacturer.◀

Do not touch the bulbs
Do not touch the glass of new bulbs with

your bare hands, as even minute amounts of
contamination will burn into the bulb's surface
and reduce its service life.
Use a clean tissue, cloth or something similar, or
hold the bulb by its base.◀

Light-emitting diodes installed behind a cover
serve as the light source for controls, display el‐
ements and other equipment.
These light-emitting diodes, which are related
to conventional lasers, are officially designated
as Class 1 light-emitting diodes.

Do not remove the covers
Do not remove the covers, and never stare

into the unfiltered light for several hours; other‐
wise, irritation of the retina could result.◀

Condensation can form on the inside of the ex‐
ternal lamps in cool or humid weather. When the
light is switched on, the condensation evapo‐
rates after a short time. The headlamp glasses
do not need to be changed.
If there is a large amount of moisture, e.g., water
droplets form in the lamp, have it checked by
your service center.

1 High beams/headlamp flasher
2 Parking lamps
3 Low beams
4 Turn signal/side marker light

1 Parking lamps/daytime running lights*
2 Low beams/high beams/headlamp flasher
3 Turn signal/side marker light

Follow the general instructions on lamps and
bulbs, refer to page 

.

55-watt bulb, H7

Seite 222

222

Online Edition for Part no. 01 40 2 606 190 - 12 10 500