BMW 2011 X3 xDrive35i Manual Do Proprietário
Brief status display
Brief display in the speedometer:
Selected desired speed
If --- appears briefly, conditions may not be ad‐
equate to operate the system.
equate to operate the system.
PDC Park Distance Control*
The concept
In addition to the PDC Park Distance Control, the
backup camera*, refer to page
backup camera*, refer to page
, can be
switched on.
PDC supports you when parking. Objects that
you are approaching slowly in front of or behind
your vehicle are indicated with:
PDC supports you when parking. Objects that
you are approaching slowly in front of or behind
your vehicle are indicated with:
▷
Signal tones.
▷
Visual display.
Measurement
Measurements are made by ultrasound sensors
in the bumpers.
The range is approx. 6 ft/2 m.
An acoustic warning is first given:
in the bumpers.
The range is approx. 6 ft/2 m.
An acoustic warning is first given:
▷
By the front sensors and two rear corner
sensors at approx. 24 in/60 cm.
sensors at approx. 24 in/60 cm.
▷
By the rear middle sensors at approx. 5 ft/
1.50 m.
1.50 m.
System limits
Check the traffic situation as well
PDC cannot serve as a substitute for the
PDC cannot serve as a substitute for the
driver's personal judgment of the traffic situa‐
tion. Check the traffic situation around the vehi‐
cle with your own eyes. Otherwise, an accident
could result from road users or objects located
outside of the PDC detection range.
Loud noises from outside and inside the vehicle
may prevent you from hearing the PDC's signal
tone.◀
tion. Check the traffic situation around the vehi‐
cle with your own eyes. Otherwise, an accident
could result from road users or objects located
outside of the PDC detection range.
Loud noises from outside and inside the vehicle
may prevent you from hearing the PDC's signal
tone.◀
Avoid driving quickly with PDC
Avoid approaching an object quickly.
Avoid approaching an object quickly.
Avoid driving away quickly while PDC is not yet
active.
For technical reasons, the system may other‐
wise be too late in issuing a warning.◀
active.
For technical reasons, the system may other‐
wise be too late in issuing a warning.◀
Limits of ultrasonic measurement
The detection of objects can reach the physical
limits of ultrasonic measurement, for instance:
limits of ultrasonic measurement, for instance:
▷
With tow bars and trailer hitches.
▷
With thin or wedge-shaped objects.
▷
With low objects.
▷
With objects with corners and sharp edges.
Low objects already displayed, e.g., curbs, can
move into the blind area of the sensors before or
after a continuous tone sounds.
High, protruding objects such as ledges may not
be detected.
move into the blind area of the sensors before or
after a continuous tone sounds.
High, protruding objects such as ledges may not
be detected.
False warnings
PDC may issue a warning under the following
conditions even though there is no obstacle
within the detection range:
conditions even though there is no obstacle
within the detection range:
▷
In heavy rain.
▷
When sensors are very dirty or covered in
ice.
ice.
▷
When sensors are covered in snow.
▷
On rough road surfaces.
▷
In large buildings with right angles and
smooth walls, e.g., in underground garages.
smooth walls, e.g., in underground garages.
▷
In heavy exhaust.
▷
Due to other ultrasound sources, e.g.,
sweeping machines, high pressure steam
cleaners or neon lights.
sweeping machines, high pressure steam
cleaners or neon lights.
Switching on automatically
Select transmission position R with the engine
running.
running.
Switching off automatically
The system switches off and the LED goes out:
Seite 93
93
Online Edition for Part no. 01 40 2 606 190 - 12 10 500