BMW 2010 Z4 sDrive30i Manual Do Proprietário

Página de 254
Under the hood
204
>
"Measurement inactive. Have this 
checked."
Do not add engine oil. You can continue 
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer 
to page
. Have the system checked as 
soon as possible.
Adding engine oil
Do not add 1 US quart/1 liter of engine oil until 
a corresponding message is shown on the 
Control Display.
Add oil within the next 125 miles/200 km; 
otherwise, the engine damage could 
occur.
<
Keep oils, greases, etc. out of the reach of 
children and comply with the relevant 
warnings on the containers. Otherwise, health 
hazards may result.
<
Oil change
Have oil changed only at your BMW center or at 
a workshop that works according to BMW 
repair procedures with correspondingly trained 
personnel.
Oil types
Do not use oil additives as these may 
cause engine damage.
<
Specified engine oils
Your service center can advise you on which 
engine oils have been approved by the manu-
facturer of your vehicle.
The engine oil quality is critical for the life of the 
engine.
Approved oils can be identified by the following 
specification:
Approved oils belong to the following viscosity 
classes: SAE 0W-40, SAE 0W-30, SAE 5W-40 
and SAE 5W-30.
Alternative oil types
If the approved engine oils are not available, up 
to 1 US quart/1 liter of another oil with the fol-
lowing specification may be used:
API SM or higher
Coolant
Do not add coolant to the cooling system 
when the engine is hot. Escaping coolant 
can cause burns.
<
Coolant consists of half water and half additive. 
Not all commercially available additives are suit-
able for your BMW. Ask your BMW center for 
suitable additives.
Only use suitable additives; otherwise, 
engine damage may result. Because 
additives are harmful to your health, it is 
important to follow the instructions on the con-
tainers.
<
Comply with the appropriate environ-
mental protection regulations when dis-
posing of coolant additives.
<
Checking coolant level
1.
Do not open the engine hood before the 
engine has cooled down.
2.
Turn the expansion tank cap counterclock-
wise slightly to allow any accumulated pres-
sure to escape, then continue turning 
to open.
Preferred:
BMW Longlife-01
BMW Longlife-01 FE
Alternative:
BMW Longlife-98
Online Edition for Part no. 01 41 2 602 883 - © 08/09 BMW AG