BMW 2010 X3 xDrive30i Manual Do Proprietário

 69

The integrated universal remote control can 
replace as many as three hand-held transmit-
ters for various radio-controlled accessories, 
such as garages, exterior gates, or lighting sys-
tems. The integrated universal remote control 
recognizes and learns the transmitted signal of 
each of the original hand-held transmitters.
The signal of an original hand-held transmitter 
can be programmed on one of the three mem-
ory buttons

1. Then, the programmed memory 

button

1 can operate the device whenever the 

ignition is switched on. The LED

2 indicates 

transmission of the signal.
Should you sell your vehicle one day, be sure to 
delete the stored programs beforehand for your 
security, refer to page

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always inspect 
the immediate area to make certain that no peo-
ple, animals or objects are within the travel range 
of the device. Also, comply with the safety pre-
cautions of the original hand-held transmitter.

<

If you see this symbol on the packaging 
or in the manual supplied with the origi-
nal hand-held transmitter, then it is safe 

to assume that the radio-controlled device is 
compatible with the integrated universal 
remote control.

If you have additional questions, please 
ask at your BMW Sports Activity Vehicle 

Center or call: 1-800-355-3515.
You can find also information on the Internet at:
www.bmwusa.com or 
www.homelink.com. 
HomeLink is a registered trademark of 
Johnson Controls, Inc.

<

1 Memory buttons
2 LED

1.

Turn the ignition key to position 2.

2.

For initial use: press the left and right mem-
ory button

1 for approx. 20 seconds until 

the LED

2 flashes rapidly. All stored pro-

grams are deleted.

3.

Hold the original hand-held transmitter at a 
distance of approx. 4 in/10 cm to 12 in/
30 cm from the memory buttons

1.

The required distance between the 
hand-held transmitter and memory 

buttons

1 depends on the relevant system 

of the original hand-held transmitter used.

<

4.

Simultaneously press the transmit button 
on the original hand-held transmitter and 
the desired memory button 

1 of the inte-

grated universal remote control. Initially, the 
LED

2 flashes slowly. Release both buttons 

as soon as the LED

2 flashes rapidly. If the 

LED

2 does not flash rapidly after approx. 

15 seconds, then change the distance and 
repeat the step.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.
You can use the system when the engine is run-
ning or when the ignition is switched on.

Online Edition for Part no. 01 41 2 602 348 - © 02/09 BMW AG