BMW 2010 550i Sedan Manual Do Proprietário

Practical interi

acc

ess

orie

118

Partition net

Do not allow the partition net to snap
back, otherwise there is a risk of injury

and the partition net may be damaged.

With normal cargo bay

Pull the partition net out of the case by the loop.
Grip the bar on both ends and insert it into the
retaining fixtures, arrow

1. This is best carried

out from the rear seat.
When you no longer require the partition net,
grip both ends of the bar and take it out of the
retaining fixtures, arrow

2. Then slowly allow the

partition net to glide into the case.

With an expanded cargo bay

Fold down both rear backrests, refer to
Expanding cargo bay.

Use the buttons to unlatch the casing on
both sides, arrow

Pull the casing out backwards, arrow

without tilting it.

Push the case into the guides on the backs
of the backrests.

Carefully pull out the partition net and insert
it in the front brackets as described in With
normal cargo bay. This is best carried out
from the front seat.

To restore the original state, proceed in the
reverse order. Finally, lay the case in the two
side brackets and then press forward until it
engages. The red warning indicator disappears
in the recess when the catch is engaged. Check
whether the case is properly locked in place by
pulling it with a sudden movement.

Compartment in floor

Automatic luggage compartment roller cover:
the opened floor panel strikes against the lug-
gage compartment roller cover in the end posi-
tion. If necessary, unhook the luggage compart-
ment roller cover at the rear before opening the
floor panel.

To open, reach into the recess and swing up the
handle.
The floor panel flap can be locked.