BMW 2010 550i Sedan Manual Do Proprietário

Things

to re

memb

er when

driving

126

the road surface, ultimately undermining your
ability to steer and brake the vehicle.

The risk of hydroplaning increases as the tread
depth of the tires decreases, refer also to Mini-
mum tire tread on page

208

Driving through water

Do not drive through water on the road if it
is deeper than 1 ft/30 cm, and then only at

walking speed at the most. Otherwise, the vehi-
cle's engine, the electrical systems and the
transmission may be damaged.

Using parking brake on inclines

On inclines, do not hold the vehicle in
place for a long time by riding the clutch;

use the parking brake. Otherwise greater clutch
wear will result.

Braking safely

Your BMW is equipped with ABS as a standard
feature. In situations that require it, it is best to
brake with full force. Since the vehicle maintains
steering responsiveness, you can still avoid
possible obstacles with a minimum of steering
effort.
Pulsation of the brake pedal, combined with
sounds from the hydraulic circuits, indicate that
ABS is in its active mode.

Do not drive with your foot resting on the
brake pedal. Even light but consistent

pedal pressure can lead to high temperatures,
brake wear and possibly even brake failure.

Driving in wet conditions

When roads are wet or there is heavy rain,
briefly exert gentle pressure on the brake pedal
every few miles. Monitor traffic conditions to
ensure that this maneuver does not endanger
other road users. The heat generated in this
process helps dry the pads and rotors to ensure
that full braking efficiency will then be available
when you need it.

Hills

To prevent overheating and the resulting
reduced efficiency of the brake system,

drive long or steep downhill gradients in the
gear in which the least braking is required. Even
light but consistent pressure on the brake can
lead to high temperatures, brake wear and pos-
sibly even brake failure.

The braking effect of the engine can be further
increased by downshifting, if necessary all the
way down into first gear. This strategy helps
you avoid placing excessive loads on the brake
system. For information on downshifting in the
manual mode of the automatic transmission,
refer to page

Do not drive with the clutch depressed, in
idle or with the engine switched off, other-

wise there will be no engine braking action or
support of the braking force and steering.
Never allow floor mats, carpets or any other
objects to protrude into the area of movement
of the pedals and impair their operation.

Corrosion on brake rotors

When the vehicle is driven only occasionally,
during extended periods when the vehicle is not
used at all, and in operating conditions where
brake applications are less frequent, there is an
increased tendency for corrosion to form on
rotors, while contaminants accumulate on the
brake pads. This occurs because the minimum
pressure which must be exerted by the pads
during brake applications to clean the rotors is
not reached.
Should corrosion form on the brake rotors, the
brakes will tend to respond with a pulsating
effect that even extended application will fail to
cure.

When vehicle is parked

Condensation forms in the air conditioner sys-
tem during operation, and then exits under the
vehicle. Traces of condensed water under the
vehicle are therefore normal.

Cargo loading

To avoid loading the tires beyond their
approved carrying capacity, never over-

load the vehicle. Overloading can lead to over-