BMW 2010 550i Sedan Manual Do Proprietário

lity

235

riv

g ti

uni

iga

When mounted at an angle, the tow bar will
exert lateral forces, tending to push the
vehicle sideways.

Only attach the tow bar to the tow fittings,
as attachment to other vehicle parts can

lead to damage.

With tow rope

When starting off in the towing vehicle, make
sure that the tow rope is taut.

To avoid jerking and the associated
stresses on vehicle components when

towing, always use nylon ropes or nylon straps.
Only attach tow ropes to the tow fittings, as
attachment to other vehicle parts can lead to
damage.

With tow truck

Have the BMW transported with a tow truck
with a so-called lift bar or on a flat bed.

With a tow truck: xDrive

Do not tow a BMW with xDrive with just
the front or rear axle raised, otherwise the

wheels could lock up and the transfer case
could be damaged.

Have the BMW transported only on a flatbed
surface.

Tow-starting

Do not tow-start the vehicle if possible, but
instead start the engine by means of jump start-
ing, refer to page

232

. With a catalytic con-

verter, tow-starting should only be carried out
with the engine cold, and with automatic trans-
missions, the engine cannot be started by tow-
starting.

Switch on the hazard warning flashers,
comply with country-specific regulations.

Switch on the ignition, refer to page

Shift into 3rd gear.

Tow-start with the clutch completely
depressed and slowly release the clutch.
After the engine starts, immediately
depress the clutch again completely.

Stop at a suitable location, remove the tow
bar or rope and switch off the hazard warn-
ing flashers.

Have the vehicle checked.