BMW 2009 M6 Coupe Manual Do Proprietário

 77

5.

Change to upper field if necessary. Turn the 
controller until "Check Control messages" 
is selected and press the controller.

6.

Select a message and press the controller.

To exit from the menu immediately:
Select the 

 arrow and press the controller.

Depending on the equipment, the stored Check 
Control messages are also displayed with the 
following symbols:

No malfunctions detected in the moni-
tored systems.
Malfunctions are present in the moni-
tored systems. Depending on the mal-
function, supplementary information is 
shown on the Control Display.

The symbols also indicate the status of the ser-
vice requirements display, refer to page

.

Malfunction reports generated during the trip 
are shown consecutively when you switch off 
the ignition.
Before the display disappears, you can display 
the messages once again. Press the CHECK 
button for approx. 2 seconds. If several mes-
sages are present, you can continue to press 
the CHECK button to view them in succession.
The display goes out:

>

after a short time

>

when you press the CHECK button again 
for approx. 2 seconds

You can enter a speed and a Check Control 
message indicates when you have reached this 
speed. This enables you, for example, to 
receive warnings if you exceed a speed limit in 
an urban area.
You are only warned of reaching this speed a 
second time if your vehicle speed falls below it 
again by at least 3 mph/5 km/h.

iDrive, for operating principle refer to page

.

1.

Open the start menu.

2.

Open "Navigation".
Without navigation system

: Open "Car 

Data".

3.

Select "Car Data" and press the controller.

4.

Select "Limit" and press the controller.

Online Edition for Part no. 01 41 2 600 775 - © 08/08 BMW AG