BMW 2008 650i Coupe Manual Do Proprietário

116

If the device fails to function even after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions for the original hand-held transmit-
ter or hold down the programmed memory 
button

1 of the integrated universal remote 

control. If the LED

2 on the integrated universal 

remote control flashes rapidly for a short time 
and then remains lit for approx. 2 seconds, this 
indicates that the original hand-held transmitter 
uses an alternating-code system. In the case of 
an alternating-code system, program the mem-
ory buttons

1 as described at Alternating-code 

hand-held transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions for 
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters 
that employ an alternating code, please observe 
the following supplementary instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled equipment.

2.

Program the integrated universal remote 
control as described above in Fixed-code 
hand-held transmitters.

3.

Locate the button on the receiver of the 
device to be set, e.g. on the drive unit.

4.

Press the button on the receiver of the 
equipment to be set. After step 4, you have 
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 

of the integrated universal remote control 
three times.

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have any additional questions, 
please contact your BMW center.

<

Press the left and right-hand memory button

1 

for approx. 20 seconds until the LED

2 flashes. 

All stored programs are deleted.
Programs cannot be deleted individually.

1.

Hold the original handheld remote control 
approx. 10 to 30 cm away from the memory 
buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the particular 

system of the original hand-held transmitter 
used.

<

2.

Press the desired memory button

1 of the 

integrated universal remote.

3.

If the LED

2 flashes slowly after approx. 

20 seconds, press the command button of 
the original hand-held transmitter. As soon 
as the LED

2 flashes rapidly, release both 

buttons. If the LED

2 does not flash rapidly 

after approx. 15 seconds, alter the distance 
and repeat the step.

Press the button. The glove compartment 
opens automatically and the lamps come on.

To prevent injury in the event of an acci-
dent while the vehicle is being driven, 

close the glove compartment immediately after 
use.

<

Online Edition for Part no. 01 41 0 014 242 - © 08/07 BMW AG