BMW 2007 X3 3.0si SAV Manual Do Proprietário

106

bracket. To do so, loosen the bolt, refer to 
arrow, and place the reservoir to one side.

Bear in mind that the windshield washing 
system reservoir is heavy. Failure to take 

this into account can lead to personal injury or 
damage to the vehicle.

<

For bulb replacement procedure, refer to 
Driver's side.

H7 bulb, 55 watts

Always wear gloves and eye protection – 
the atmosphere inside the H7 bulb is 

pressurized. Failure to observe this precaution 
can lead to injuries should the bulb be dam-
aged.

<

For checking and adjusting headlamp 
aim, please contact your BMW Sports 

Activity Vehicle Center.

<

1.

Open the clip and remove the lamp cover.

2.

Press the bulb holder downward and 
remove, refer to Low beams.

3.

Pull off the lamp base; plug in a new lamp 
base.

4.

Place the lamp base with the lower edge 
against the bracket and press it in until the 
lamp base locks into place.

Make sure that the cover does not fall into 
the engine compartment; otherwise, the 

vehicle can be damaged or other road users can 
be endangered.

<

Before replacing the bulb, remove the reservoir 
of the windshield washer system from the 
bracket, refer to Halogen low beams on 
page

For bulb replacement procedure, refer to 
Driver's side.

W5W bulb, 5 watts
A bulb is located over each high beam.

1.

Remove bulb cover for high beams, refer to 
Halogen high beams.

2.

Remove bulb holder.

3.

Remove and replace the bulb.

PSY24WSV bulb, 24 watts
Access to the turn signal is at the edge of the 
lamp unit, refer to arrow.

Make sure that the lamp base does not fall 
into the engine compartment; otherwise, 

the vehicle can be damaged or other road users 
can be endangered.

<

1.

Turn the lamp base and remove it.

2.

Replace the bulb.

3.

Insert the lamp base. If it does not snap into 
place immediately, turn the lamp base until 
it does.

 Online Edition for Part no. 01 41 0 013 638 - © 03/07 BMW AG