BMW 2007 X3 3.0si SAV Manual Do Proprietário

Practical interi

acc

ess

orie

The corresponding memory button

1 is now

programmed with the signal of the original
hand-held transmitter.
You can use the system when the engine is run-
ning or when the ignition is switched on.

If the system cannot be operated after
repeated programming, check whether

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button

1 of the integrated universal

remote control. If the LED

2 on the integrated

universal remote control flashes rapidly for a
short time then lights up for approx. 2 seconds,
this indicates that the original hand-held trans-
mitter uses an alternating-code system. In the
case of an alternating-code system, program
the memory buttons

1 as described in the sec-

tion below on alternating-code hand-held
transmitters.

Alternating-code hand-held

transmitters

Consult the operating instructions of the unit
you wish to set when programming the univer-
sal remote control. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please follow
these additional instructions:

Programming will be easier with the aid of
a second person.

Park your vehicle within the range of the
remote-controlled equipment.

Program the integrated universal remote
control as described above in the section on
Fixed-code hand-held transmitters.

Locate the button on the receiver of the
equipment to be set, e.g. on its drive unit.

Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.

Press the programmed memory button

of the integrated universal remote control
three times.

The corresponding memory button

1 is now

programmed with the signal of the original
hand-held transmitter.

If you have questions, please contact your
BMW Sports Activity Vehicle Center.

Deleting stored programs

Press the left and right memory button

1 for

approx. 20 seconds until the LED

2 flashes rap-

idly.
All stored programs are deleted.
It is not possible to delete individual programs.

Digital compass*

1 Adjusting button
2 Display
The display indicates the cardinal or intercardi-
nal direction in which you are currently driving.

Basic operation

You can call up a number of functions by press-
ing the adjusting button with a sharp object
such as a ball-point pen or the like. The follow-
ing possible adjustments are displayed one
after another, depending on how long you press
and hold the adjusting button:

Press briefly: switches display on/off

3 to 6 seconds: set compass zone

6 to 9 seconds: calibrate compass

9 to 12 seconds: set for left-hand/right-
hand drive

12 to 15 seconds: set language