BMW 2007 X5 4.8i SAV Manual Do Proprietário

111

riv

g ti

uni

iga

lity

The corresponding memory button

1 is now

programmed with the signal of the original
hand-held transmitter.
You can operate the device when the engine is
running or when the ignition is switched on.

If the device cannot be used after
repeated programming, check whether

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button

1 of the integrated universal remote

control. If the LED

2 on the integrated universal

remote control flashes rapidly for a short time
and then remains lit for approx. 2 seconds, this
indicates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons

1 as described at Alternating-code

hand-held transmitters.

Alternating-code hand-held
transmitters

To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:

Programming will be easier with the aid of
a second person.

Park your vehicle within the range of the
remote-controlled device.

Program the integrated universal remote
control as described above in the section
Fixed-code hand-held transmitters.

Locate the button on the receiver of the
device to be set, e.g. on the drive unit.

Press the button on the receiver of the
device to be set. After step 4, you have
approx. 30 seconds for step 5.

Press the programmed memory button

of the integrated universal remote control
three times.

The corresponding memory button

1 is now

programmed with the signal of the original
hand-held transmitter.

Should you have questions, please con-
tact your BMW Sports Activity Vehicle

Center.

Deleting stored programs

Press both outer memory buttons

1 for approx.

20 seconds until the LED

2 flashes:

All stored programs are deleted.
Individual programs cannot be deleted.

Digital compass*

1 Adjustment button
2 Display
The display indicates the cardinal or intercardi-
nal direction in which you are currently driving.

Operating principle

You can run various functions by pressing the
adjustment button with a pointed object, e.g. a
ball-point pen etc. The following setting options
are displayed consecutively, depending on how
long the adjustment button is pressed:

Press briefly: switch display on/off

3 to 6 seconds: set compass zone

6 to 9 seconds: calibrate compass

9 to 12 seconds: set left/right-hand drive
vehicle

12 to 15 seconds: set language