BMW 2007 X5 4.8i SAV Manual Do Proprietário

Opening and

closing

Please make sure that all electronic sys-
tems/consumers are switched off before

locking to save the battery.

Comfort closing

Hold a finger or the back of a hand on the sur-
face, arrow

The windows and the panorama glass sunroof

are closed.

Watch during the closing process to be
sure that no one is injured. Removing the

hand from the door handle stops the closing
process immediately.

Opening liftgate

Press the button on the liftgate.
This corresponds to pressing the

button.

If a remote control accidentally left in the
cargo bay is detected in the locked vehi-

cle after closing the liftgate, the liftgate opens
again. The hazard warning flashers flash and a
signal

sounds.

Switching on radio readiness

By briefly pressing the Start/Stop button, you
switch on the radio readiness, refer to page

When doing so, do not depress the brake
pedal, otherwise the engine will start.

Starting engine

You can start the engine or switch on the igni-
tion if a remote control is located in the interior
of the vehicle. It need not be inserted in the igni-
tion lock, refer to page

As long as no remote control is detected in the
vehicle, it is only possible to restart the engine
within approx. 10 seconds after it is switched off
if no door has been opened.

Switching off engine

Remote control not in ignition lock:
After switching off the engine, the transmis-
sion is automatically switched into trans-
mission position P.

Remote control in ignition lock:
If transmission position N is engaged, the
transmission remains in this position after
the engine is switched off.

Before driving into a car wash

The vehicle can roll if you proceed according to
the following steps:

Insert remote control into ignition lock.

Depress brake pedal.

Engage transmission position N.

Release the parking brake.

Switch off the engine.

Leave the remote control in the ignition
lock.

Malfunction

The comfort access function may malfunction
due to local radio waves. Then open or close the
vehicle with the buttons on the remote control
or with a key. To start the engine following this,
insert the remote control in the ignition lock.

The warning lamp in the instrument
cluster lights up when an attempt is
made to start the engine: starting the

engine is not possible. The remote control is
not in the vehicle or has a malfunction. Take
along the remote control into the vehicle or
have it checked. Insert another remote control
into the ignition lock if necessary.

The warning lamp in the instrument
cluster lights up when the engine is
running: the remote control is no

longer in the vehicle. After switching off the
engine, the engine can only be started again
within approx. 10 seconds if no door has been
opened.

The indicator lamp in the instrument
cluster flashes and a message
appears on the Control Display:

replace the battery of the remote control.