BMW 2007 750i Sedan Manual Do Proprietário

112

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.
You can operate the system when the engine is 
running or when the ignition is switched on.

If the device cannot be used after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions of the original hand-held transmit-
ter or press and hold down the programmed 
memory button

1 of the integrated universal 

remote control. If the LED

2 on the integrated 

universal remote control flashes rapidly for a 
short time and then remains lit for approx. 
2 seconds, then this indicates that the original 
hand-held transmitter is equipped with an alter-
nating-code system. In the case of an alternat-
ing-code system, program the memory but-
tons 

1 as described in the Alternating-code 

hand-held transmitters section below.

<

Consult the operating instructions of the unit 
you wish to set when programming the univer-
sal remote control. You will find information 
there on the possibilities for synchronization.
When programming hand-held transmitters 
that employ an alternating code, please follow 
the supplementary instructions below:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device.

2.

Program the integrated universal remote 
control as described above in the Fixed-
code hand-held transmitters section.

3.

Locate the button on the receiver of the 
device you want to set up, e.g. on the upper 
section of its drive unit.

4.

Press the button on the receiver of the 
device you want to set up. After step 4, you 
have approx. 30 seconds for step 5.

5.

Press the programmable memory button

1 

on the integrated universal remote control 
three times.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have any additional questions, 
please contact your BMW center.

<

Press the left and right memory buttons

1 for 

approx. 20 seconds until the LED

2 flashes rap-

idly:
All stored programs are deleted.
It is not possible to delete individual programs.

Briefly press the button on the driver's door with 
the ignition in radio ready state or higher.

1 Quarter window blind
2 Side window blind
3 Rear window blind

Online Edition for Part no. 01 41 0 013 316 - © 02/07 BMW AG