BMW 2007 750i Sedan Manual Do Proprietário

Driving

Do not allow the engine to warm up by leaving it
running while the vehicle remains stationary.
Instead, start driving right away, at a moderate
engine speed.

Switching off engine

When leaving the vehicle, always take the
remote control with you.

With the vehicle stationary, briefly press the
Start/Stop button. Radio ready state is switched
on.
The transmission automatically shifts to posi-
tion P: interlock.

Before driving into a car wash

To permit the vehicle to roll, take the following
steps:

With Comfort Access: insert remote control
into ignition lock.

Shift transmission into position N.

Switch engine off.

Leave the remote control in the ignition
lock.

The transmission will shift into position P:

automatically after approx. 30 minutes

if you remove the remote control from the
ignition lock

Pay attention to the messages on the Info Dis-
play.

Removing remote control from ignition
lock

Press in the remote control briefly; it pops part-
way out. This procedure will also switch off the
ignition if it is on.

Comfort function

To switch off the engine when the vehicle is sta-
tionary, press the Start/Stop button for longer
than approx. 2 seconds. The remote control
pops partway out.

Parking brake

The concept

Your BMW is equipped with an electromechan-
ical parking brake.
The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked.
You can use the parking brake in two ways:

Manually, by briefly pressing the button

Automatically, by activating the Automatic
Hold mode, refer to page

An electrohydraulic mechanism then engages
the parking brake to prevent the rear wheels
from turning whenever you switch off the
engine.
When the engine is running, parking brake
engagement is controlled by the brake sys-
tem's hydraulic circuits, which act on the disc
brakes in the front and rear wheels.

Brake pedal feel

The hydraulic brake system can produce a
slightly different braking feel. Engagement may
also be accompanied by activation noise – this
is normal.

Manual engagement

Briefly press the button, the word PARK
appears on the Info Display.
When the parking brake is engaged, the indica-
tor lamp

on the Info Display lights up red,

refer to page

The remote control does not have to be
inserted into the ignition lock for the parking
brake to be set.