BMW 2007 328xi Sedan Manual Do Proprietário

 107

The integrated universal remote control can 
replace as many as three hand-held transmit-
ters for various remote-controlled devices, 
such as door openers and house alarm sys-
tems. The integrated universal remote control 
registers and stores signals from the original 
hand-held transmitters.
The signal of an original hand-held transmitter 
can be programmed on one of the three mem-
ory buttons

1. After this, the programmed 

memory button

1 will operate the system in 

question. The LED

2 flashes to confirm trans-

mission of the signal.
Should you sell your vehicle one day, be sure to 
delete the stored programs beforehand for your 
safety, refer to page

108

.

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always inspect 
the immediate area to make certain that no peo-
ple, animals or objects are within the pivoting or 
travel range of the device being operated. Com-
ply also with the safety instructions supplied 
with the original hand-held transmitter.

<

If this symbol appears on the package 
or in the instructions supplied with the 
original hand-held transmitter, you can 

assume that the radio remote control device will 
be compatible with the integrated universal 
remote control.
For additional information, please contact your 
BMW center or call: 1-800-355-3515.
You can also obtain information on the Internet 
at: 
www.bmwusa.com or 
www.homelink.com. 

HomeLink is a registered trademark of Johnson 
Controls, Inc.

<

1 Memory buttons
2 LED

1.

Switch on the ignition, refer to page

.

2.

When starting operation for the first time: 
Press both outer memory buttons

1 for 

approx. 20 seconds until the LED

2 flashes. 

The three memory buttons are cleared.

3.

Hold the original hand-held transmitter at a 
distance  of  approx.  2 to  8 in/5 to  20 cm  from 
the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the system of the 

respective original hand-held transmitter 
used.

<

4.

Simultaneously press the transmit key on 
the original hand-held transmitter and the 
desired memory button 

1 on the integrated 

universal remote control. The LED 

2 flashes 

slowly at first. As soon as the LED

2 flashes 

rapidly, release both buttons. If the LED

2 

does not flash rapidly after approx. 15 sec-
onds, alter the distance.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

Online Edition for Part no. 01 41 0 012 928 - © 08/06 BMW AG