BMW 2006 M5 Sedan Manual Do Proprietário

riv

g ti

uni

iga

lity

Locking

Press the

button.

Switching on interior lamps

With vehicle locked:
Press the

button.

You can also use this function to locate your
vehicle in parking garages etc.

Panic mode*

You can also trigger the alarm system in case of
danger:
Press the

button for at least 3 seconds.

Switch off alarm: press any button.

Opening luggage compartment lid

Press the

button for approx. 1 second.

The luggage compartment lid opens, regard-
less of whether it was previously locked or
unlocked.

During opening, the luggage compart-
ment lid pivots back and up. Ensure that

adequate clearance is available before opening.
To prevent accidentally locking yourself out,
never lay the remote control in the luggage
compartment. A previously locked luggage
compartment lid is also locked again after clos-
ing.

Setting confirmation signals

You can vary or also deactivate the confirmation
signals for locking or unlocking.

Open the start menu.

Press the controller to open the menu.

Select "Vehicle settings" and press the
controller.

Select "Door locks" and press the control-
ler.

Select "Confirmation" and press the con-
troller.

Select the desired signal.

Press the controller.

The signal is activated.

Malfunctions

The remote control may malfunction due to
local radio waves. Should the remote control fail
to operate owing to interference of this kind,
unlock and lock the vehicle via the door lock
using a key.
If it is no longer possible to lock the vehicle
using the remote control, then the battery is
discharged. Use this remote control during an
extended drive; this will recharge the battery,
refer to page

For US owners only

The transmitter and receiver units comply with
part 15 of the FCC/Federal Communication
Commission regulations. Operation is gov-
erned by the following:
FCC ID:
LX8766S
LX8766E
LX8CAS
LX8CAS2
Compliance statement:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:

This device must not cause harmful inter-
ference, and

this device must accept any interference
received, including interference that may
cause undesired operation.