BMW 2006 530i Sedan Manual Do Proprietário

112

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.
You can operate the system when the engine is 
running or when the ignition is switched on.

If the device can not be used after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions for the original hand-held transmit-
ter or hold down the programmed memory 
button

1 of the integrated universal remote 

control. If the LED

2 on the integrated universal 

remote control flashes rapidly for a short time 
and then remains lit for approx. 2 seconds, this 
indicates that the original hand-held transmitter 
uses an alternating-code system. In the case of 
an alternating-code system, program the mem-
ory buttons

1 as described at Alternating-code 

transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions for 
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters 
that employ an alternating code, please observe 
the following supplementary instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device.

2.

Program the integrated universal remote 
control as described above in the section 
Fixed-code hand-held transmitters.

3.

Locate the button on the receiver of the 
device to be set, e.g. on the drive unit.

4.

Press the button on the receiver of the 
device to be set. After step 4, you have 
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 

of the integrated universal remote control 
three times.

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have any additional questions, 
please contact your BMW center.

<

Press both outer memory buttons

1 for approx. 

20 seconds until the LED

2 flashes:

All stored programs are deleted.
Individual programs cannot be deleted.

Press the button on the driver's door.

Pull the loop of the roller sun blind and hook 
onto bracket.

Online Edition for Part No. 01 41 0 012 211 - © 02/06 BMW AG