BMW 2006 530i Sedan Manual Do Proprietário

 89

If the HDC display goes out in the HDC mode or 
is not shown:
HDC is temporarily not available, as the brake 
temperature is too high.

Dynamic Drive minimizes body roll and opti-
mizes vehicle stability during cornering and 
evasive maneuvers.
Dynamic Drive is based on active stabilizers on 
the front and rear axles. Suspension compli-
ance adapts to suit driving conditions, varying 
from performance-oriented during cornering to 
smooth and comfort-oriented when the vehicle 
is proceeding in a straight line. During vehicle 
operation, the system continuously runs 
through closed-loop control cycles lasting only 
fractions of a second.
The system assumes operational status each 
time you start the engine.

The warning lamp lights up yellow and 
a message is shown on the Control Dis-
play. There is a malfunction in the sys-

tem. Have the system checked as soon as pos-
sible.

If a malfunction occurs, please remember 
to adapt your speed accordingly, espe-

cially in curves. 
The suspension will be noticeably softer and 
the vehicle will display a greater tendency to tilt 
during cornering and in crosswinds. 
If a message stating that you should stop is 
shown on the Control Display, stop at a suitable 
location and switch off the engine as soon as 
possible. In this case the oil level in the reservoir 
may have dropped below the minimum, possi-
bly owing to a leak in the hydraulic system. 
Do not continue driving, but instead contact 
your BMW center.

<

xDrive: the vehicle is raised somewhat at 
the rear after locking. This is normal and is 

linked to minor noises.

<

The warning lamp for self-leveling sus-
pension lights up yellow and a message 
is shown on the Control Display. A mal-

function has occurred in the self-leveling sus-
pension. Stop and check the vehicle. If it is con-
siderably lower at the rear than at the front, and 
possibly also on one side – rear left compared to 
rear right –, go to the nearest BMW center or a 
workshop that works according to BMW repair 
procedures with correspondingly trained per-
sonnel. Drive with appropriate caution in the 
meantime. The vehicle has reduced ground 
clearance and driving comfort may be notice-
ably reduced. Even if the position of the vehicle 
is normal, go to the nearest BMW center or a 
workshop that works according to BMW repair 
procedures with correspondingly trained per-
sonnel.

The Flat Tire Monitor keeps track of the infla-
tion pressures in the tires as you drive. The sys-
tem provides an alert whenever the inflation 
pressure drops significantly in relation to the 
pressure in another tire.
In the event of a pressure loss, the rolling radius 
and therefore the rotation speed of the wheels 
change. This change is detected and is 
reported as a flat tire.

In order to assure the reliable reporting of a flat 
tire, the system must be initialized for the cor-
rect tire inflation pressure.

Online Edition for Part No. 01 41 0 012 211 - © 02/06 BMW AG