BMW 2006 M3 Coupe Manual Do Proprietário

139

To repair a flat tire using the M Mobility 
system, proceed as follows:
> Fill with sealant, refer to page 

> Distribute the sealant, refer to 

> Restore tire inflation pressure, refer 

.

1. Shake the bottle of sealant
2. Screw hose 9 onto the opening of 

the sealant bottle

3. Twist the dust cap off of the valve on 

the flat tire and screw filler hose 2 
connected to the sealant bottle onto 
the valve

4. Insert the sealant bottle into the con-

nector on the compressor so that it is 
standing upright

5. Make sure that the system is 

switched off, position 0

6. Insert connector 3 into the cigarette 

lighter socket inside the vehicle, refer 
to page 

7. When using the version with the 

manometer on the hose: make sure 
that screw 8 on the pressure gauge 
is tightened down

8. With the ignition key in position 2:

Switch on the compressor and keep 
it running for approx. 3 minutes to fill 
in the sealant. It does not matter 
what the tire's inflation pressure is 
afterward

9. Turn the system off and disconnect 

the hose from the sealant bottle and 
the wheel valve. Stow the M Mobility 
system in the vehicle.

Right afterward, drive at least about 
2 miles / 3 km, so that the sealant is 
distributed evenly in the tire.

Do not exceed a maximum speed 
of 35 mph / 60 km/h.

If possible, keep the vehicle speed 
above 12 mph / 20 km/h.

<

1. After driving approx. 1.9 miles/3 km, 

pull over at a suitable location

2. Screw hose 9 connected to the com-

pressor directly onto the tire valve

3. Insert connector 3 into the cigarette 

lighter socket inside the vehicle

Online Edition for Part-No. 01 41 0 158 512 - © 09/04 BMW AG