BMW 2006 750i Sedan Manual Do Proprietário

Manual engagement

Briefly press the button, the word PARK
appears on the Info Display.
When the parking brake is engaged, the indica-
tor lamp

on the Info Display lights up red,

refer to page

The remote control does not have to be
inserted into the ignition lock for the parking
brake to be set.
It is only possible to disengage the parking
brake with the ignition on.
If exceptional circumstances should make it
necessary to engage the parking brake while
the vehicle is in motion, maintain pressure on
the button.
The indicator lamp on the Info Display lights up
in red and a chime sounds, the brake lamps light
up.
The vehicle continues to brake forcefully for as
long as you maintain pressure on the button.
When you brake the vehicle almost to a stop,
i.e., down to a speed of approximately 2 mph/
3 km/h or below, the parking brake remains
engaged.

Manual release

Briefly press the button with the ignition
switched on.
The indicator lamp

on the Info Display goes

out.

As long as the remote control is inserted
into the ignition lock, you can also release

the parking brake after the engine has been
switched off. This function is useful, for exam-
ple, in automatic car washes, refer to

124

When leaving the vehicle, always bring
the remote control with you; this precau-

tion prevents children from disengaging the
parking brake, etc.

Automatic Hold

You can activate the system after starting the
engine; it then remains operational until the
next time the engine is switched off.
This feature provides additional assistance dur-
ing vehicle operation by automatically engaging
and releasing the parking brake during stops at
traffic lights, in stop-and-go traffic, etc. The
vehicle is automatically held in place so as to
suppress the tendency to creep when the
transmission is in drive.
It also prevents the vehicle from rolling back-
ward during uphill starts.
The parking brake engages automatically when
you stop the vehicle and switch off the engine.
You can activate or deactivate Automatic Hold
via the "Settings" menu in iDrive.

Activation/deactivation

iDrive, for principle details, refer to page

Press the

button to open the start

menu.

Move the controller toward "Settings".

Select "Vehicle" and press the controller.

Select "AUTO P". Press the controller to
activate/deactivate the desired function.

Automatic Hold is activated.
The green AUTO P status message on the
Info Display indicates that the system is
ready for operation.

Automatic Hold is deactivated.
The green AUTO P status message disap-
pears from the Info Display.