BMW 2006 325xi Sports Wagon Manual Do Proprietário

120

any instructions provided by the bulb manufac-
turer.

<

For care and maintenance of the headlamps, 
please follow the instructions in the separate 
Caring for your vehicle brochure.

If the routine for changing a particular 
bulb is not described here, please contact 

your BMW Center or a workshop that works 
according to BMW repair procedures with cor-
respondingly trained personnel.

<

Light-emitting diodes installed behind translu-
cent lenses serve as the light source for many of 
the controls and displays in your vehicle. These 
light-emitting diodes, which operate using a 
concept similar to that applied in conventional 
lasers, are officially designated as Class 1 light-
emitting diodes.

Do not remove the covers or expose the 
eyes directly to the unfiltered light source 

for several hours at a time, otherwise this could 
cause irritation to the retina.

<

The service life of these bulbs is very long and 
the probability of a failure is very low, provided 
that they are not switched on and off an unusual 
number of times. If a xenon lamp fails neverthe-
less, switch on the fog lamps and continue the 
journey with great care, provided that local leg-
islation does not prohibit this.

Have work on the xenon lighting system 
performed only by your BMW Center or a 

workshop that works according to BMW repair 
procedures with correspondingly trained per-
sonnel. Due to the high electrical voltages 
present, there is a risk of potentially fatal acci-
dents if work is performed inappropriate.

<

In the event of a malfunction, please contact 
your BMW Center or a workshop that works 
according to BMW repair procedures with cor-
respondingly trained personnel.

H7 bulb, 55 watts

Always wear gloves and eye protection; 
the atmosphere within the H7 bulb is 

pressurized. Otherwise there is a risk of injury if 
the bulb is damaged.

<

There are separate headlamp covers for low-
beam headlamps and high-beam headlamps.

Be careful when installing the covers, oth-
erwise leaks could occur and cause dam-

age to the headlamp system.

<

For checking and adjusting headlamp 
aim, please contact your BMW Center.

<

The high-beam headlamp can be accessed 
from the engine compartment, whereas the 
low-beam headlamp is accessed through a flap 
in the wheel well.

1 Cover for high-beam headlamp
2 Cover for low-beam headlamp
3 Turn signal bulb socket
To remove the covers:

1.

Fold the respective wire bracket to the side, 
see arrows.

2.

Flip open the cover and take it out of the 
guide.

Follow the same steps in reverse order to reat-
tach the covers.

Only for low-beam headlamps and turn signals:

Online Edition for Part-No. 01 41 0 012 353 - © 03/06 BMW AG