BMW 2005 X3 2.5i SAV Manual Do Proprietário

t a

lanc

riv

g tip

ilit

Replacing components

Onboard tool kit

The onboard tool kit is located in a compart-
ment on the left in the cargo area.

Replacing wiper blades

Front

Move the wiper into the fold-out position,
refer to page

Lift the wiper arm and press the securing
spring, refer to arrow.

Pull the wiper blade off toward the wiper
arm.

Insert the new blade and snap it into place.

Fold the wipers back down onto the wind-
shield before you turn the ignition key to

position 1 or 2 again. If you do not, they could be
damaged.

Rear

Lift the wiper arm.

Pull off the wiper blade, refer to arrow.

Insert a new wiper blade.

Lamps and bulbs

The lamps and bulbs make essential contribu-
tions to the safety of your vehicle. Therefore,
comply fully with the following instructions dur-
ing bulb replacement. If you are not familiar with
the specified procedures, BMW recommends
having the replacements carried out at your
BMW Sports Activity Vehicle Center.

Never touch the glass of new bulbs with
your bare fingers, as even minute

amounts of contamination will burn into the
bulb's surface and reduce its service life. To
install, use a clean cloth, napkin etc. or hold the
bulb by its metal socket.

A replacement bulb set is available from your
BMW Sports Activity Vehicle Center.

To prevent short circuits, before working
on any electrical system, equipment or

accessory you should always switch it off and
disconnect the cable from the battery's nega-
tive terminal before starting.
To avoid possible injury or equipment damage
when replacing bulbs, observe any instructions
provided by the bulb manufacturer.

When maintaining the headlamps, please
comply with the instructions in the sepa-

rate Caring for your vehicle brochure.