BMW 2005 325xi Sedan Manual Do Proprietário

nection to an outside antenna. Otherwise, the
vehicle electronics and mobile communication
device can influence one another. In addition,
there is no assurance that the radiation which
results from transmission will be dissipated
from the vehicle interior.

Interior and exterior mirrors, automatic

dimming feature*

The automatic dimming feature of the interior
and exterior mirrors

is controlled by two photo

cells in the interior rearview mirror. One photo
cell is in the mirror frame, see arrow; the other is
on the back of the mirror.
In order to ensure that the system functions
correctly, keep the photo cells clean, do not
cover the area between the interior rearview
mirror and windshield, and do not affix adhesive
labels or stickers of any kind to the windshield
directly in front of the mirror.

Hydroplaning

When driving on wet or slushy roads,
reduce road speed. If you do not, a wedge

of water can form between tires and road sur-
face. This situation, known as hydroplaning,
means that the tire can completely lose contact
with the road surface, so that neither the car can
be steered nor the brake be properly applied.

The risk of hydroplaning increases with declin-
ing tread depth on the tires, refer also to Mini-
mum tread depth on page

115

Driving through water

Drive through water on the road only if it is
not deeper than 1 ft/30 cm, and then only

at walking speed at the most. Otherwise, the

vehicle's engine, the electrical systems and the
transmission may be damaged.

Use the handbrake on inclines

On inclines, do not hold the vehicle with
the clutch; use the handbrake. Otherwise

greater clutch wear will result.

Sequential manual gearbox SMG

On uphill slopes, drive off without delay.
Do not hold the vehicle in place by

depressing the accelerator pedal; apply the
handbrake instead. Otherwise, the transmis-
sion could overheat.

Also use the drive-off assistant, refer to
page

Braking safely

Your BMW is equipped with ABS as a standard
feature. Applying the brakes fully is the most
effective way of braking in situations in which
this is necessary. Since the vehicle maintains
steering responsiveness, you can still avoid
possible obstacles with a minimum of steering
effort.
Pulsation of the brake pedal, combined with
sounds from the hydraulic circuits, indicate that
ABS is in its active mode.

Driving in wet conditions

When roads are wet or there is heavy rain,
briefly exert gentle pressure on the brake pedal
every few miles. Monitor traffic conditions to
ensure that this maneuver does not endanger
other road users. The heat generated in this
process helps dry the pads and rotors to ensure
that full braking efficiency will then be available
when you need it.

Hills

To prevent overheating and the resulting
reduced efficiency of the brake system,

drive long or steep downhill gradients in the
gear in which the least braking is required. Even
light but consistent brake pressure can lead to
high temperatures, brake wear and possibly
even brake failure.