BMW 2004 Z4 Roadster 2.5i Manual Do Proprietário

Replacement procedures

Onboard tool kit

The onboard tool kit is stored in a tool
pouch. It is located in the luggage compart-
ment beneath the floor panel.

Windshield wiper blades

Fold the wiper arm completely out from
the windshield

Position the wiper blade at an angle and
pull the release spring, see arrow

Fold the wiper blade down and unhook
it toward the windshield

Pull the wiper blade past the wiper arm
toward the top

Insert a new wiper blade and apply
pressure until you hear it engage.

Lamps and bulbs

The lamps and bulbs make essential contri-
butions to the safety of your vehicle. There-
fore, comply fully with the following instruc-
tions during bulb replacement. If you are
not familiar with the procedures, BMW rec-
ommends that you have your BMW center
carry out the work.

Do not touch the glass portion of
a new bulb with your bare hands

since even small amounts of impurities
burn in to the surface and reduce the ser-
vice life of the bulb. Use a clean cloth,
paper napkin or a similar material, or hold
the bulb by its metallic base.

A replacement bulb set is available from
your BMW center.

Before working on the electrical sys-
tem, switch off the electrical acces-

sory you are working on or disconnect the
cable from the negative terminal of the bat-
tery. Failure to observe this precaution
could result in short circuits.
To prevent injuries and damage, always
comply with any instructions provided by
the bulb manufacturer.

Accessing the headlamps

Protective cover in the wheel well

To gain access to the headlamp covers,
turn the front wheels in the required direc-
tion.