After parking the vehicle and switching off
the headlamps, operating the headlamp
flasher activates the low beams. You can
set the duration on the Control Display or
deactivate the function.

Control Center, for principle details, refer to
page

Open the menu

Select "Vehicle settings" and press the
controller

Select "Lighting" and press the control-
ler

Select "Pathway lighting" and press the
controller

Turn the controller to select the corre-
sponding duration

Press the controller to apply the setting.

Lights on warning

If you turn the ignition key to position 0, an
acoustic signal sounds when you open the
driver's door for a few seconds to remind
you that the lamps have not yet been
switched off. At the same time a message
appears on the Control Display.

Daytime driving lamps*

If you wish, you can leave the light switch in
the low-beam position.

Always observe all applicable laws govern-
ing the use of daytime driving lamps.

You can switch on the parking lamps when
needed using the standard procedure
described under Parking lamps.

Automatic headlamp control

When you set the switch to this
position, the system activates and
switches on and off the low beams

in response to changes in ambient light
conditions, for instance, in a tunnel, at
dawn and dusk, and in rain and snow.
The LED next to the symbol is illuminated
when the low beams are on.

The low beams remain on indepen-
dent of the ambient lighting condi-

tions when you switch on the fog lamps.
With the daytime driving lamps activated,
the low beams are always switched on in