BMW Automobile 325xi Manual Do Proprietário

 85

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.
You can operate the system when the engine is 
running or when the ignition is switched on.

If the system fails to function even after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions for the original hand-held transmit-
ter or hold down the programmed memory 
button

1 of the integrated universal remote 

control. If the LED

2 on the integrated universal 

remote control flashes rapidly for a short while 
and then remains lit for about two seconds, the 
original hand-held transmitter uses an alternat-
ing-code system. If it uses an alternating-code 
system, program the memory buttons

1 as 

described under Alternating-code hand-held 
transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions for 
the device to be set. You will find information 
there on the possibilities for synchronization.
When programming hand-held transmitters 

that employ an alternating code, please observe 
the following supplementary instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device.

2.

Program the integrated universal remote 
control as described above in the section 
Fixed-code hand-held transmitters.

3.

Locate the button on the receiver of the 
device to be set, e.g. on the drive unit.

4.

Press the button on the receiver of the 
device to be set. After step 4, you have 
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 of 

the integrated universal remote control 
three times.

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have any questions, please contact 
your BMW Center.

<

Press both outer memory buttons

1 for approx. 

20 seconds until the LED

2 flashes: all stored 

programs are cleared.
It is not possible to clear individual programs.

1 Adjustment button
2 Display
The display shows you the main or secondary 
direction in which you are driving.

Depending on the vehicle's geographic loca-
tion, the relevant compass zone must be set. 

Online Edition for Part-No. 01 41 0 012 353 - © 03/06 BMW AG