BMW 535I XDRIVE Manual Do Proprietário

213

"Measuring engine oil level...":
This can take about 3 minutes if the car is at
a standstill on a level surface and the engine
is running, and about 5 minutes while the
car is moving.
If the engine oil has been topped off, the
measurement of the oil level can take up to
30 minutes.

"Engine oil level below minimum. Add 1
quart!":
Add a maximum of 1 literUS quart/liter of
engine oil at the next opportunity, refer also
to Adding engine oil below. If the oil level
displayed is below minimum, add engine oil
immediately. Failure to do so may lead to
engine damage.

"Engine oil level too high! Have this
checked.":

Too much oil will harm the engine.
Have the vehicle checked without

delay.

"Measurement inactive. Have this
checked.":
Do not add engine oil. You can continue
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer
to Service requirements on page

. Have

the system checked as soon as possible.

Adding engine oil

1 US quart/1 liter of engine oil until a corre-
sponding message is shown on the Control Dis-
play.

Add oil within the next 125 miles/200 km,
otherwise the engine could be dam-

aged.

Continuous exposure to used oil has
caused cancer in laboratory testing.

For this reason, thoroughly wash exposed areas
of skin with soap and water after such work.
Keep oil, grease, etc., out of reach of children
and observe the warnings on the containers to
prevent health risks.

Oil change

Have oil changed only at your BMW center or
at a workshop that works according to BMW
repair procedures with correspondingly trained
personnel.

Approved engine oils

The quality of the engine oil selected has critical
significance for the operation and service life of
an engine. BMW continuously approves spe-
cific oils after confirming their suitability for use
in its vehicles with extensive testing.

Do not use oil additives, as these may
result in engine damage.

Only use approved BMW High Performance
Synthetic Oil.
If BMW High Performance Synthetic Oil is
unavailable, you can add small quantities of
other synthetic oils between oil changes. Only
use oils of the specification API SM or higher.

Your BMW center will be happy to answer
detailed questions on BMW High Perfor-

mance Synthetic Oil or approved synthetic
oils.

You can also call BMW of North America at
1-800-831-1117 or visit the website at
www.bmwusa.com to obtain this information.

Viscosity grades

Viscosity is a measure of an oil's flow rating and
is specified in SAE grades.
The choice of the right SAE grade is based on
the climatic conditions in the region in which
you normally drive your BMW.

Approved oils belong to the 0W-40,
0W-30, 5W-40 and 5W-30 SAE

classes.