BMW 2004 745Li Sedan Manual Do Proprietário

 41

then flashes continuously. The tilt alarm 
sensor and the interior motion sensor are 
switched off as long as the system is 
armed. 

If you desire, the 

>

tilt alarm sensor 

>

interior motion sensor 

can be switched off permanently. Please 
contact your BMW center for assistance.

<

 

In order for the interior motion sensor to 
function properly, the windows and glass 
roof must be completely closed. 

Be sure to deactivate the interior motion 
sensor, refer to section on Avoiding unin-
tentional alarms, when you wish to leave 
the windows or glass roof open. 

From radio mode on: 

>

Press the switch until you feel resis-
tance:
The window continues to move down-
ward as long as you continue to hold 
the switch 

>

Briefly press the switch beyond the 
resistance point: 
The window moves downward auto-
matically. Briefly press the switch again 
to stop the opening movement. 

You can close the windows in the same 
manner by pulling the switch.

You can still operate the power windows:

>

For approx. 15 minutes with the remote 
control unit in the radio mode 

>

For approx. 1 minute in position 0 or 
with the remote control unit disen-
gaged.

To open, press the switch beyond the 
resistance point. 

When leaving the vehicle parked, 
always remove the remote control 

from the ignition lock and close the doors; 
this precaution prevents children from 
operating the power windows and injuring 
themselves, etc.

<

 

For information on using the convenience 
operation mode at the door lock or with the 
remote control, refer to page 

If the force rises beyond a predefined 
threshold during closing, the system will 
stop moving the window prior to lowering it 
slightly. 

Despite this safety feature you should 
always inspect the window's travel 

path prior to closing it, as the safety system 
might fail to detect certain kinds of obstruc-
tions, such as very thin objects, and the 
window would continue closing. 
Pulling the switch beyond the resistance 
point and holding it limits the response of 
the safety feature. Under these conditions 
the window will respond to forces beyond a 
defined threshold by only opening several 
millimeters. 
If you again pull the switch past the resis-
tance point and hold it in position within a 
period of roughly 4 seconds, the safety fea-
ture will be deactivated.

<

 

When you close the windows they will 
slow down as they approach the end 

of their travel; this is to allow the safety fea-
ture to respond more precisely to any 
obstructions encountered in this critical 
range.

<

 

Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG