BMW 2004 745Li Sedan Manual Do Proprietário
61
The transmission automatically shifts to
position P: interlock.
position P: interlock.
<
If the remote control is still in the ignition
lock when the driver's door is opened, a
gong will sound and a message will appear
in the Info Display.
lock when the driver's door is opened, a
gong will sound and a message will appear
in the Info Display.
Starting the engine
Do not run the engine in closed
rooms, as otherwise the inhaling of
rooms, as otherwise the inhaling of
toxic exhaust gases can cause uncon-
sciousness and death. The exhaust gases
contain carbon monoxide, an odorless and
colorless, but highly toxic gas.
Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety hazard.
sciousness and death. The exhaust gases
contain carbon monoxide, an odorless and
colorless, but highly toxic gas.
Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety hazard.
<
1.
Insert the remote control all the way into
the ignition lock. With Comfort Access,
this is not required
the ignition lock. With Comfort Access,
this is not required
2.
Press the brake pedal
3.
Briefly press the start/stop button.
Your BMW is equipped with the con-
venience starting feature. After press-
venience starting feature. After press-
ing the brake pedal, all you need to do is
briefly press the start/stop button.
The system responds by automatically
engaging the starter and allowing it to run
until the engine starts, after which it then
disengages automatically.
The automatic starting mode will not oper-
ate or will be canceled if the battery voltage
is low. The engine can be started by jump-
starting, refer to page
briefly press the start/stop button.
The system responds by automatically
engaging the starter and allowing it to run
until the engine starts, after which it then
disengages automatically.
The automatic starting mode will not oper-
ate or will be canceled if the battery voltage
is low. The engine can be started by jump-
starting, refer to page
<
Do not allow the engine to warm up by
leaving it running while the vehicle remains
leaving it running while the vehicle remains
stationary. Instead, drive off immediately at
a moderate engine speed.
a moderate engine speed.
If you have accidentally switched off
the engine while driving, it can be
the engine while driving, it can be
restarted from a speed of approx. 3 mph/
5 km/h by pressing the button. It is not nec-
essary to press the brake pedal.
5 km/h by pressing the button. It is not nec-
essary to press the brake pedal.
<
Under the following conditions you should
press the accelerator pedal halfway down
when starting:
press the accelerator pedal halfway down
when starting:
>
If the engine fails to start on the first
attempt, for instance, if it is very hot or
cold
attempt, for instance, if it is very hot or
cold
>
During a cold start at high altitudes,
from approx. 3,281 ft/1,000 m, at very
low temperatures, from approx. + 57/
–156.
from approx. 3,281 ft/1,000 m, at very
low temperatures, from approx. + 57/
–156.
Refrain from starting the vehicle
repeatedly at brief intervals, and
repeatedly at brief intervals, and
avoid an excessive number of starting
attempts if the vehicle fails to start;
repeated activation of the starter over an
extended period would allow unburned or
only partially combusted fuel to enter the
catalytic converter, where it can cause
overheating and damage to the unit.
attempts if the vehicle fails to start;
repeated activation of the starter over an
extended period would allow unburned or
only partially combusted fuel to enter the
catalytic converter, where it can cause
overheating and damage to the unit.
<
Switching off the engine
With the vehicle stationary, briefly press the
start/stop button. This also activates the
radio mode.
start/stop button. This also activates the
radio mode.
The transmission automatically shifts to
position P: interlock.
position P: interlock.
Transmission position N remains
engaged if you keep to the following
engaged if you keep to the following
order:
1.
With Comfort Access: insert the remote
control into the ignition lock
control into the ignition lock
2.
With the engine running, engage trans-
mission position N
mission position N
3.
Switch off the engine
4.
Leave the remote control in the ignition
lock.
lock.
This function is useful in automatic car
washes, etc.
Position P is engaged automatically after
washes, etc.
Position P is engaged automatically after
Online Edition for Part No. 01 41 0 157 670 - © 08/03 BMW AG